Best Way to Attach Ledger Board to House
Flashing a Deck Ledger Board on Vinyl Siding
Here's the right fashion to do it
Attaching a deck ledger board to a vinyl-sided house requires a few actress trim pieces to keep h2o from leaking behind the siding. Here's a rundown of the materials and process.
You lot might also like: TBD
Installing the flashing
Slip flashing under siding
Snap a chalk line, cut out the siding and tack up the ledger board. Then skid flashing backside the siding, covering the top edge of the ledger.
Outset by making an outline on the siding where you want to position the ledger board. Make the outline big enough to include infinite for the deck boards on superlative, the ledger and any trim boards on the sides. And so cutting away the siding.
Nail undersill trim (J-aqueduct volition too piece of work) over the bottom cut, using xi-approximate aluminum nails. It's a tight fit to drive the nails into the undersill, but you can gently pull dorsum the siding, then tuck it into the undersill after yous nail information technology. If necessary, remove a few pieces of siding, nail the undersill, then replace the siding.
Tack Z-flashing over the channel, extending information technology slightly past the cutout on both sides. If y'all need two or more pieces of flashing, overlap the joints by four in. and seal with silicone caulk. Avert using galvanized flashing with ACQ treated lumber because it tin can cause corrosion.
Nail J-channel along both sides of the cutout. Then tack the ledger into place with 16d nails. Adjacent, slide drip flashing behind the vinyl then the lip fits over the superlative of the ledger every bit shown at right. Install undersill trim along the edge of the vinyl, over the flashing at the top and lesser.
Then lag-screw the ledger to the house using the fastener pattern canonical in your plan. A building inspector we talked to said that incorrectly installed ledgers are the main cause of problems in do-it-yourself decks considering the ledger may pull loose from the firm. Make sure to get a building let before starting a deck project so the inspector tin can check the ledger installation. Information technology'southward extremely important for the ledger to be firmly attached.
Finally, caulk around the bolt heads to seal the holes against moisture.
Required Tools for this Projection
Have the necessary tools for this DIY project lined up before you start—you'll relieve time and frustration.
You'll demand a zip tool to remove vinyl siding.
Required Materials for this Project
Avoid final-infinitesimal shopping trips by having all your materials gear up ahead of time. Hither'southward a list.
galleghanpailtaild.blogspot.com
Source: https://www.familyhandyman.com/project/flashing-a-deck-ledger-board-on-vinyl-siding/
0 Response to "Best Way to Attach Ledger Board to House"
Post a Comment